Lunaria Pendant Tutorial

Create the Bezel Base: Pick up: 1 × SuperDuo → 1 × Delica → 1 × SuperDuo → 1 × Delica. Repeat until you have 6 SuperDuos and 6 Delicas, alternating. Form into a circle and reinforce the thread path. Add the Outer Layer: Step up into the second hole of each SuperDuo. Between each, add: 1 × 15/0 → 1 × Delica → 1 × 15/0. Continue around to complete the outer embellishment ring. Add the Second SuperDuo Layer: Between each outer group, add another SuperDuo, forming the second layer. Pass through the new SuperDuos’ top holes to continue building upward. Add Pico Trim on Delicas: At the center Delica of each trio: Add: 1 × 15/0 → 1 × Delica → 1 × 15/0. Stitch into the next center Delica to form pico trim points around the bezel. Insert Rivoli: Place the 14mm rivoli face-up in the center. Pull thread tight to form a snug bezel around the crystal. Reinforce: Stitch around the bezel again, going through 15/0s and Delicas to lock the rivoli in place. Flip and reinforce the backside of the bezel if needed. Add Crystals Between SuperDuos: Between each SuperDuo on the outer ring: Add: 1 × 15/0 → 1 × 3mm bicone → 1 × 15/0. Stitch into the next SuperDuo to continue embellishing. Build the Bail: Exit from a top SuperDuo. Add: 1 × 15/0 → 1 × 11/0 → 1 × 3mm bicone → 1 × 11/0 → 1 × 15/0. Loop back into the same SuperDuo and reinforce the loop 2–3 times. Reinforce and Tie Off: Stitch through multiple beads in the bezel and trim thread. Use half-hitch knots or bridge knots to secure. Burn or cut excess thread cleanly.