Tile Square Bracelet Tutorial

Attach the First Wire Guard Begin with a thread fitted with a needle on each end, attach a wire guard to one half of the clasp, and position the thread to start the bracelet. Create the First Tile Unit Add the Tile bead, 11/0 seed beads, and 2mm crystal rounds, crisscrossing both needles through the appropriate beads to form the first section. Build the Bracelet Base Repeat the bead sequence, connecting additional Tile beads with seed beads and crystals until the bracelet reaches the desired length. Attach the Second Wire Guard Secure the opposite end of the bracelet with another wire guard, reinforcing the connection with multiple thread passes. Begin the Side Embellishments Weave one thread into position and stitch curved rows of two 11/0 seed beads, one 2mm crystal, and two more 11/0 seed beads around each Tile bead. Frame Each Tile Bead Continue repeating the embellishment pattern along one side of the bracelet to create decorative square frames. Embellish the Opposite Side Return to the second thread and repeat the same crystal-and-seed-bead pattern on the opposite side of each Tile bead. Reinforce the Clasp Area Pass through the wire guard again to strengthen the attachment, then bring both thread ends together. Finish the Thread Tie secure knots, weave the thread into the beadwork if desired, and trim or burn the excess thread. Complete the Bracelet Attach jump rings and your preferred clasp, then check the bracelet for even tension and enjoy your finished Tile Square Bracelet.