Riviera Bracelet Tutorial

Start the Bracelet Add a stop bead and three 11/0 seed beads, then begin the first unit with alternating 4mm crystals (or pearls), 15/0 seed beads, and Half Tila beads. Form the First Component Complete the sequence of four Half Tila beads and four 4mm beads, then sew back through the starting crystal and beads to create a square-like unit. Reverse Through the Half Tila Beads Pass through the second hole of each Half Tila bead, adding 15/0 seed beads between them to pull the design together. Add the Interior Seed Beads Stitch 11/0 seed beads between the Half Tila beads to create the inner border and reinforce the component. Repeat the Pattern Continue adding new units by repeating the same bead sequence and thread path until the bracelet reaches the desired length. Reinforce Each Section Weave through the completed units to tighten the beadwork and maintain consistent thread tension throughout the bracelet. Attach the Button Clasp Secure the button clasp to one end using 11/0 seed beads, reinforcing the connection with multiple thread passes. Create the Beaded Loop Stitch a loop of approximately 31 seed beads on the opposite end, then connect it back into the bracelet to fit securely over the button clasp. Reinforce the Closure Pass through the button connection and beaded loop several times to strengthen the clasp and ensure all seed beads are aligned properly. Finish the Bracelet Tie secure finishing knots, weave the thread into the beadwork, trim or burn the thread ends, and enjoy your completed Riviera Bracelet.